-----Ursprungliche Nachricht-----
Von: Abd ul-Rahman Lomax [mailto:[EMAIL PROTECTED]]
Gesendet: Dienstag, 27. November 2001 21:29
An: Protel EDA Forum
Betreff: Re: [PEDA] Layer Specific Keep out.
At 02:31 PM 11/27/01 -0400, Tim Fifield wrote:
>Is it possible to have a layer specific keep out? I want a GND trace
>connecting two components, however, there is a GND polygon between the two
>components as well. I do not want the trace to touch the polygon. Is there
a
>way to do this without drawing the polygon around the track?
Two possible ways. I haven't used it much, but you can set the polygon to
*not* "pour over same net."
You can also draw a thin track around the trace and give it the keepout
attribute. (In the track edit dialog, not by putting it on the keepout
layer). This will cause the polygon to keep away from the track even if it
would otherwise pour over it.
[EMAIL PROTECTED]
Abdulrahman Lomax
Easthampton, Massachusetts USA
This works fine, but to add a trace with the keep- out attribute, I had to
set
it for each track segment. Strange enough, the global edit feature for this
attribute is not allowed.
I tried an old command ( Shortcut mOVE bRAKE ) to add bending points.
Have you got an idea to make this better.
Georg
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
