My rule of thumb for 68 pin PLCC sockets Don't exceed 24Mhz & replace the IC in the socket no more than 4 times. Passing analog signals through the socket is a no-no...
When using 48Mhz, do not replace the IC more than 2 times. These are my personal rule and they do not conform to any standards out there. ____________ Brian Guralnick ----- Original Message ----- From: "Lloyd Johnson" <[EMAIL PROTECTED]> To: "Protel EDA Forum" <[EMAIL PROTECTED]> Sent: Friday, April 19, 2002 9:15 PM Subject: [PEDA] PLCC Socket reliability | This may be slightly off topic, but we are beginning to have occasional | problems with the reliability of the connections between a 68 pin low | profile PLCC socket and a 68 pin IC package. | | Are low profile sockets (Millmax 540-99-068-17-400200) less reliable than | full height PLCC sockets? Or are PLCC sockets for larger parts just | inherently a bad idea? | | This socket uses the same footprint as the PLCC part, so we can change to | direct soldering the part in place if this is needed. | | Any thoughts would be appreciated. | | Lloyd Johnson, DSS | Vista CA. | | * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
