can anyone advise me on the following please?
i am about to do a design for a 150,000 pc run
for cost reasons (low end commercial product) the bd material must be
made out of night soil (actually phenolic)
the design is SMD and to be a single sided bd (one etch layer)!
the lead pitch is 0.5mm on a 108 PQFP and a 48 PQFP
trace density and net count will be low so i think it will be routable
so the question is:
are there etch considerations, lead pitch minimums or other
considerations regarding the material?
i.e. can you actually put a 108 PQFP on phenolic and reflow it properly?
i guess CEM might be a possible choice
every dime is $15K, so this stuff matters
we are not going to do a proto, just going right to the run
(only kidding!)
Dennis Saputelli
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *