Yuri, while your drag for a single component may be working, I am sure that I recall something else will stop working as desired. I cannot recall exactly what is involved but with the Options Drag setting enabled I remember that there is something else which does not function correctly. Sorry that I can't recall exactly what was effected and the Protel KB comes up with nothing related if you search for "component drag", "drag", "connected tracks".
Sincerely, Brad Velander. Lead PCB Designer Norsat International Inc. Microwave Products Tel (604) 292-9089 (direct line) Fax (604) 292-9010 email: [EMAIL PROTECTED] http://www.norsat.com -----Original Message----- From: ElectronTrade (info) [mailto:[EMAIL PROTECTED]] Sent: Tuesday, July 09, 2002 12:41 AM To: Protel EDA Forum Subject: [PEDA] Re[2]: Re[2]: Drag Selection in PCB Editor Hi Peter, PB> Protel will do "drag connected tracks" for a single component - but if PB> set to do this, you can't rotate components (think of the mess you'd get PB> if you could drag tracks while rotating components!) In P99SE, the PB> selection is under "Tools/Preferences/Options - Component Drag". Thank you for help. Also thanks to Dave and Igor. Now my Drag for single component is working. ************************************************************************ * Tracking #: 4A91187EB5081E4AAAE623437E891A6B569B248F * ************************************************************************ -- Best regards, Yuri V. Potapoff Technical Director ElectronTrade, Ltd. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *