I cant believe what i have seen today ... after the PCB manufactor has reported errors in gerber files
Protel 99SE SP6 Image a track surrounded by a polygon. The track has a 45 degree corner. on the outter side protel(as seen in draft mode) places a short ARC at the corner, but in GERBER (as seen by camtastic) there is a track connected from and to the points where the arc should be. And because this is so, the clearance rule is not followed. i have setup the clearance rule to 8mil for the whole board, but due to the BUG (Protel are you listening ??) the effektive clearance is 6.2 - 6.4 mil at the edges and so the board cost much more .... has anybody a solution for that ???? is it realy so bad that i cannot trust PROTEL that the gerber files do not contain what i see . even in draft mode i would expect to see what is in gerber. an ARC is an ARC and NOT a TRACK !! (BTW: The PCB manufactor does not use CAMTASTIC and he also does not see the arc, so i guess .. there must be a track in the gerberfiles ...) Dipl.-Ing. (FH) Michael Schmitt Baumer Ident GmbH Entwicklung / Development Department Hertzstr. 10 D-69469 Weinheim Deutschland / Germany Tel. +49 (0) 6201 9957 - 30 Fax. +49 (0) 6201 9957 - 99 E-Mail : [EMAIL PROTECTED] Web: <http://www.baumerident.com/> ************************************************************************ * Tracking #: 02BF3DF5B4996947B95A0D11AD368F2ECE55A179 * ************************************************************************ * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
