For this purpose, I use square pads with a gap of 0.2mm ( 8 mil ) This works fine. Don't forget to remove the solder mask between the pads.
Georg -----Urspr ngliche Nachricht----- Von: Steve Smith [mailto:[EMAIL PROTECTED]] Gesendet: Donnerstag, 5. September 2002 15:03 An: 'Protel EDA Forum' Betreff: [PEDA] Solder jumper Is it possible in 99SE to have a round pad with a 10 mil gap through the center to create a jumper that you solder when a connection is required? I know that the "Lomax Virtual Short" is similar but we want a single pad (or two halves of a pad) instead of two separate pads. Thanks, Steve Smith Product Engineer Staco Energy Products Co. Web Site: www.stacoenergy.com ************************************************************************ * Tracking #: 1ABAF690937FE742B12D2C792B897FF903DEABAC * ************************************************************************ * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
