I was using P99SE. It was a challenge. Also knowing what I know now, I would have approached the design differently and might have placed higher in the rankings. But be that as it may, it was a good run for the money and I was in very good company at the time too. It was back in March of 2000 at PCB West in Santa Clara.
Heheh.. you crack me up... ! I know you drive much farther than I do Bro... You live out in the toolies... That's why you drive that Jeep isn't it? No it wasn't a long trip for me... Maybe 40 min. They held the classes down in Mira Mesa in the old training center for one of those ITT Tech schools of some sort. I wish it had been at Altium HQ that would have been even closer for me. Bill Brooks PCB Design Engineer , C.I.D., C.I.I. Tel: (760)597-1500 Ext 3772 Fax: (760)597-1510 Trip? what trip, aren't you located there in Vista there just about 20 minuites away from Altium North Amarica over there in South Escondido? Respecting Top Gun, mentioned by Mike in a parallel post, I didn't know that you participated. Was that at PCB West? What did you use, Protel 99 SE, DXP, Protel 2004, or Mentor Expedition (which I know you can also drive)? JaMi * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
