JOE the ERC will not flag PORTS (AFAIK) power ports and other stuff yes it is interesting that it really doesn't want to let you place a port unless it is going to be connected
you can trick it or move it later but try to just place one in the air, it will erase it automatically if it was not at least initially connected Dennis Saputelli Joe Sapienza wrote: > > Yes Jeff what most of us do is run an ERC(electrical Rules Check), it is > evoked under the tools dropdown > > ----- Original Message ----- > From: "Jeff Condit" <[EMAIL PROTECTED]> > To: "Protel EDA Forum" <[EMAIL PROTECTED]> > Sent: Tuesday, September 07, 2004 12:46 PM > Subject: [PEDA] Unconnected Ports > > In Protel 99SE Schematic, a couple ports were positioned a few thousandths > of an inch away from a wire and hence made no connection. This made the > pins not get included in the netlist. The distance was too small to see in > a quick visual check. Is there a way to quickly mark and find unconnected > wire ends? > > Jeff Condit > -- _______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
