If you're trying to create a tempo map rather than a static tempo throughout, then you'll have to use the conductor to create tempo changes. There's probably half a chapter on that somewhere and some of it will refer to tempo markers in the ruler which are not accessible right now but the point is, while it's not simple enough to outline in too much detail, I'll try to give a basic scenario:
Enable the Conductor. Figure out what the starting tempo should be. Go to the start of the session and, using the Static tempo dialog, enter the tempo value. Go to the bar where a tempo change needs to happen and enter a new value and Apply it. repeat this process. Remember, since the individual tempo events are not accessible in the rulers yet, if you make a mistake, immediately undo it before moving on. In other words, simply don't make any mistakes. None of us do, right? Otherwise, a different approach is to have the band track at their own tempo and create bar}beat markers after the fact by using the Identify beat command. In that scenario, you go to what would be bar 1, Identify the beat with command-i and type in what the bar number should be. Move to the next tempo change and repeat this and enter what the bar number should be. Double-check as you go along to make sure that you're truly getting the bar numbers right or else the grid won't line up. Again, make no mistake, literally. That's the nut shell version. You won't really learn it until you've done it and experienced the process. reading the reference guide helps a lot so you know what the general procedure and expected results should be. Hope that helps, Slau On Aug 28, 2015, at 12:21 PM, Chad Baker <[email protected]> wrote: > hi slau that worked thanks now one quick question > i am recording a friend’s metal band and there tempos change measure to > measure > not sure what all those types of tempos like parabolic and linear mean > i just want to input different tempos for the different measures that they > want > > -- > You received this message because you are subscribed to the Google Groups > "Pro Tools Accessibility" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Pro Tools Accessibility" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
