Peter,
Thanks for your reply... thought I was having email trouble.
Here's what I've done to narrow it down to pulseaudio:
-Using arecord, record a 96khz wav file of IQ audio several minutes long on the
remote system.-Create two null sinks, both 96khz sample rate on the remote
system.-Using paplay, I play back the recorded stream (which I've verified to
be error free) to one null sink and connect the SDR application to null.monitor
over wifi.-Connect the SDR application playback stream to the other null sink
(to simulate the same network load)-Walk out to my garage for poor wifi signal
while running the SDR application... after a few seconds of stuttering I get
nothing but full volume white noise.
Unsure of what other tests to run at this point.
Thanks,
Eric Thornton
On Tuesday, January 13, 2015 11:54 AM, Peter Meerwald <[email protected]>
wrote:
> Resending.
your message has been received, it's on the list, see
http://lists.freedesktop.org/archives/pulseaudio-discuss/2015-January/022955.html
if the issue is not the underlying sound hardware, then probably it can be
reproduced with a file source and hence much easier tested/debugged?
p.
--
Peter Meerwald
+43-664-2444418 (mobile)
_______________________________________________
pulseaudio-discuss mailing list
[email protected]
http://lists.freedesktop.org/mailman/listinfo/pulseaudio-discuss
