On 12.11.2017 09:13, S.C.T.N Gmbh wrote:
Please don't top post.
pulseaudio 5.0
Linux TEST 4.9.35-v7+ #1014 SMP Fri Jun 30 14:47:43 BST 2017 armv7l
GNU/Linux (Raspbian Jessie, Raspberry Pi 3)
The only thing I changed in the config files is:
exit-idle-time = -1
In daemon.conf
That is a very old version of pulse. Can you try current 11.1 or git?
*Von:*Georg Chini [mailto:[email protected]]
*Gesendet:* Samstag, 11. November 2017 20:58
*An:* General PulseAudio Discussion; S.C.T.N Gmbh
*Betreff:* Re: [pulseaudio-discuss] WG: AW: module-sine for generating
two independent sine wave signals on the left and right output of a
sound device
On 11.11.2017 15:27, Georg Chini wrote:
On 11.11.2017 14:58, S.C.T.N Gmbh wrote:
please don't top post on that list.
Yes I can confirm that:
Pactl unload-module <index>
stops the sine output on both channels.
But in
pactl list modules short
the module<index> has disappeared while the other module-sine
is still there.
This definitely should not happen. I'll investigate and see if I can
reproduce the issue.
I cannot reproduce it here. For me it works and I can also immediately
reload module-sine after unloading. What platform are you on and
which version of PA are you using?
_______________________________________________
pulseaudio-discuss mailing list
[email protected]
https://lists.freedesktop.org/mailman/listinfo/pulseaudio-discuss
_______________________________________________
pulseaudio-discuss mailing list
[email protected]
https://lists.freedesktop.org/mailman/listinfo/pulseaudio-discuss
