I am attempting to see if my peripherals will work with Ubuntu before I wipe windows clean out of my life, one of which is a pvrusb2.
My setup is Windows XP with VM Ware workstation 5.0 and an Ubuntu Feisty Fawn installation on a virtual machine. My laptop is a Sony GRV680. When I run lsusb I see one entry for the device: Bus 001 Device 092: ID 2040:2900 Hauppauge My kernel version is 2.6.20-5-generic. When I run cat /proc/bus/usb/devices I see: ... P: Vendor=2040 ProdID=2900 Rev=4.00 S: Manufacturer=Hauppauge ... The device resets continuously, leaving similar messages in dmesg continuously: ... USB disconnect, address 113 new ful sped USB device using uhci_hcd and address 114 configuraiton #1 chosen from 1 choice Device microcontroller firmware (re)loaded; it should now reset and reconnect. USB disconnect, address 114 There is also no /dev/video0 available. This may have to do with how windows, the USB bus, the VMWare virtual machine and Ubuntu communicate, but I wanted to check here first. Has anyone tried this setup, or ran into similar problems? Any information is much appreciated. I know the hardware is working too, I just taped something in Windows. Thanks in advance for your help! -Matt _______________________________________________ pvrusb2 mailing list [email protected] http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
