On 06/12/2009 03:30 PM, Mike Isely wrote:
6. Stream some video with mplayer, either composite input or an analog
RF signal (if you can).
7. While streaming, do "cat /sys/class/pvrusb2/*/debuginfo". Capture
output, send to me.
8. Run dmesg again - you'll see a new block reporting "card status".
This is an additional effect from cat'ing debuginfo (a log request is
generated to all associated drivers). Capture that block to a file and
send it to me.
That should be enough for me to figure out what state the hardware is
getting into, either so I can solve it or at least be able to reproduce
the behavior here.
BTW, after doing all pending updates to my (newly-upgraded) f11 system,
I was able to get good video from /dev/video0 -- only thing wrong was
aspect ratio (looked to be 1:1)...
Also, when catting ...standard/cur_val, it used to say "none" before i'd
set it to NTSC-M -- but this time, it said NTSC-M after boot, all I had
to change in /sys was the input (to composite).
I'll still play with it, will try with vlc (which almost worked before,
but showed up as pal, even when the standard was specifically set to
NTSC)...
-Scott
Linux eva.ponzo.net 2.6.29.4-167.fc11.x86_64 #1 SMP Wed May 27 17:27:08
EDT 2009 x86_64 x86_64 x86_64 GNU/Linux
using stock driver, didn't have debug turned on.
_______________________________________________
pvrusb2 mailing list
[email protected]
http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
