Hi, here is the result of the command:
sylv...@sylvain-desktop2:~$ dmesg |grep pvrusb2 [ 8.143906] usbcore: registered new interface driver pvrusb2 [ 8.143933] pvrusb2: 20090509 (from www.isely.net):Hauppauge WinTV-PVR-USB2 MPEG2 Encoder/Tuner [ 8.143936] pvrusb2: Debug mask is 31 (0x1f) [ 8.144063] usb 1-2: firmware: requesting v4l-pvrusb2-29xxx-01.fw [ 8.220760] pvrusb2: Device microcontroller firmware (re)loaded; it should now reset and reconnect. [ 8.235072] pvrusb2: Device being rendered inoperable sylv...@sylvain-desktop2:~$ lsmod |grep pvrusb pvrusb2 150336 0 cx2341x 20996 1 pvrusb2 v4l2_common 20992 2 pvrusb2,cx2341x videodev 41600 1 pvrusb2 v4l1_compat 21764 2 pvrusb2,videodev tveeprom 20100 1 pvrusb2 I do the compilation of the driver version of may 2009. My hauppaupe wintv pvr usb2 device is 29032 rev D158 NTSC/NTSC-J This time I don't even get the /dev/video0... I can see that the device is inoperable but I don't know what's is the problem. Thanks for any suggestion. Sylvain. p.s. linux now run with the kernel 2.6.23-14-generic. Le mercredi 29 juillet 2009 à 19:13 +0200, Bernhard Geier a écrit : > sylvain arbour schrieb: > > Hi, > > > > I am on ubuntu 9.04 (linux 2.6.23-13-generic). I am unable to make the > > device working. When I start VLC from a terminal to open the device > > (pvr) the following error message appear: > > > > "[00000409] pvr access error: Failed to write 0 new capture card > > settings." > > > > Is someone can help with this ? Thanks in advance. > > > > Sylvain. > > > > > Did you load the module pvrusb2? AFAIK it's not prebuild in Ubuntu, so > you have to compile it on your own. > If you did load the module please post the output of > dmesg | grep pvrusb > > > > _______________________________________________ > pvrusb2 mailing list > [email protected] > http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2 _______________________________________________ pvrusb2 mailing list [email protected] http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
