Actually, I don't need the whole ACPI mechanism working.
On the real target, I want to use the power button to initiate a reboot.
Such a thing can be done with something like:
cat /proc/acpi/event | grep specific_event > /dev/null && reboot
In the qemu, I never get to load the relevant kernel modules (like button.ko), since the ACPI is disabled due to the mentioned checksum failure.
If it is only some small adaptation of the mentioned patch with checksum calculation for RSDT and updating acpi.S than I would gladly do it (do you have any hints?). Otherwise - I just give up on this now, and use the real hardware.
Cheers,
Shahar Livne
LivneX - Open Source Development and Services
http://livnex.com
On 11/8/05, Yu, Ke <[EMAIL PROTECTED]> wrote:
This is an interesting topic, however, not an easy task :)
The patch is for APIC support, and only contains one ACPI MADT entry, which is far from full ACPI support. So you may like to call it an APIC patch rather than ACPI patch.
If you want to test power management of embedded system with qemu, IMHO, there will be a lot of work to do:
* Implement ACPI hardware in QEMU, which includes
- General ACPI hardware in chipset
- Specific ACPI hardware in every device
* Add ACPI table in BIOS.
Best Regards
Yu Ke
----------------
Intel Opensource Technology Center
________________________________________
From: qemu-devel-bounces+ke.yu= [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Shahar Livne
Sent: 2005年11月9日 1:40
To: qemu-devel@nongnu.org
Subject: [Qemu-devel] ACPI support
Hi there,
I use qemu for development of embedded systems. Lately I had a need to check ACPI related kernel module, but I have seen that there isn't any support in the version 0.7.1 that I use.
I have checked also 0.7.2 and found no support.
A patch that I have found on www.h7.dion.ne.jp/~qemu-win/ for x86_64 by F.Navara seemed like close enough.
I have applied it (after adaptation, since it didn't go smooth for 0.7.1 or 0.7.2).
The system booted, but running dmesg | grep ACPI inside the embedded system on the qemu gave:
ACPI: RSDP (v000 QEMU ) @ 0x000e0000
ACPI: Invalid RSDT checksum
ACPI: Subsystem revision 20050211
ACPI: Interpreter disabled.
I use the i386 emulation, and the kernel running inside is 2.6.11
Has someone any experience with ACPI in qemu?
Thanks,
Shahar Livne
LivneX - Open Source Development and Services
http://livnex.com
_______________________________________________
Qemu-devel mailing list
Qemu-devel@nongnu.org
http://lists.nongnu.org/mailman/listinfo/qemu-devel
_______________________________________________ Qemu-devel mailing list Qemu-devel@nongnu.org http://lists.nongnu.org/mailman/listinfo/qemu-devel
