On 7/2/24 14:23, Inès Varhol wrote:
The testcase contains :
- `test_idr_reset_value()` :
Checks the reset values of MODER, OTYPER, PUPDR, ODR and IDR.
- `test_gpio_output_mode()` :
Checks that writing a bit in register ODR results in the corresponding
pin rising or lowering, if this pin is configured in output mode.
- `test_gpio_input_mode()` :
Checks that a input pin set high or low externally results
in the pin rising and lowering.
- `test_pull_up_pull_down()` :
Checks that a floating pin in pull-up/down mode is actually high/down.
- `test_push_pull()` :
Checks that a pin set externally is disconnected when configured in
push-pull output mode, and can't be set externally while in this mode.
- `test_open_drain()` :
Checks that a pin set externally high is disconnected when configured
in open-drain output mode, and can't be set high while in this mode.
- `test_bsrr_brr()` :
Checks that writing to BSRR and BRR has the desired result in ODR.
- `test_clock_enable()` :
Checks that GPIO clock is at the right frequency after enabling it.
Acked-by: Thomas Huth <th...@redhat.com>
Signed-off-by: Arnaud Minier <arnaud.min...@telecom-paris.fr>
Signed-off-by: Inès Varhol <ines.var...@telecom-paris.fr>
---
tests/qtest/stm32l4x5_gpio-test.c | 586 ++++++++++++++++++++++++++++++
tests/qtest/meson.build | 3 +-
2 files changed, 588 insertions(+), 1 deletion(-)
create mode 100644 tests/qtest/stm32l4x5_gpio-test.c
LGTM!
