Add the specs for the zoned format feature of the qcow2 driver. The qcow2 file then can emulate real zoned devices, either passed through by virtio-blk device or NVMe ZNS drive to the guest given zoned information.
Signed-off-by: Sam Li <[email protected]> Reviewed-by: Stefan Hajnoczi <[email protected]> --- docs/system/qemu-block-drivers.rst.inc | 47 ++++++++++++++++++++++++++ 1 file changed, 47 insertions(+) diff --git a/docs/system/qemu-block-drivers.rst.inc b/docs/system/qemu-block-drivers.rst.inc index 675daa72f9..1af968c4fd 100644 --- a/docs/system/qemu-block-drivers.rst.inc +++ b/docs/system/qemu-block-drivers.rst.inc @@ -172,6 +172,53 @@ This section describes each format and the options that are supported for it. filename`` to check if the NOCOW flag is set or not (Capital 'C' is NOCOW flag). + .. option:: zone.mode + If this is set to ``host-managed``, the image is an emulated zoned + block device. This option is only valid to emulated zoned device files. + + .. option:: zone.size + + The size of a zone in bytes. The device is divided into zones of this + size with the exception of the last zone, which may be smaller. + Defaults to ``256 MiB``. + + .. option:: zone.capacity + + The initial capacity value, in bytes, for all zones. The capacity must + be less than or equal to zone size. If the last zone is smaller, then + its capacity is capped. Defaults to ``zone.size``. + + The zone capacity is per zone and may be different between zones in real + devices. QCow2 sets all zones to the same capacity. + + .. option:: zone.conventional_zones + + The number of conventional zones of the zoned device. Defaults to ``0`` + (all zones are sequential-write-required). + + .. option:: zone.max_active_zones + + The limit of the zones with implicit open, explicit open or closed state. + + The max active zones must be less or equal to the number of SWR + (sequential write required) zones of the device. Defaults to ``0``, + meaning no limit. + + .. option:: zone.max_open_zones + + The maximal allowed open zones. The max open zones must not be larger than + the max active zones. Defaults to ``zone.max_active_zones`` if that is + set, otherwise ``0`` (no limit). + + If the limits of open zones or active zones are equal to the number of + SWR zones, then it is the same as having no limits. + + .. option:: zone.max_append_bytes + + The number of bytes in a zone append request that can be issued to the + device. It must be 512-byte aligned and less than the zone capacity. + Defaults to ``64 KiB``. + .. program:: image-formats .. option:: qed -- 2.53.0
