On Thu, 2026-10-15 at 11:37 +0800, Jay Chang wrote:
> The Xilinx AXI DMA controller supports 64-bit descriptor addresses,
> but the QEMU model only handled the low 32 bits during stream
> processing.  This causes descriptor accesses to use incorrect
> addresses when descriptors are located above 4 GiB.
> 
> This series updates the descriptor and MMIO handling and fixes
> related
> AXI DMA and AXI Ethernet behavior.
> 
> The series:
> 
> - Add 64-bit descriptor address handling to stream processing.
> - Add separate 32-bit and 64-bit MMIO access helpers.
> - Fix DMASR W1C and DMACR start processing behavior.
> - Reset both DMA channels when DMACR_RESET is written.
> - Do not start a transfer when TAILDESC is written while the channel
>   is halted.
> - Fix AXI Ethernet RX packet double-buffering.
> 
> Testing:
> - Tested Xilinx AXI Ethernet networking with U-Boot.
> - Tested DHCP and ping.

Thanks!

Applied to riscv-to-apply.next

Alistair

> 
> Jay Chang (6):
>   hw/dma/xilinx_axidma: Support 64-bit descriptor addressing in
> stream
>     processing
>   hw/dma/xilinx_axidma: Add 64-bit MMIO access support
>   hw/dma/xilinx_axidma: Fix DMASR register handling
>   hw/dma/xilinx_axidma: Reset both channels on DMACR_RESET
>   hw/dma/xilinx_axidma: Don't start transfer on TAILDESC write when
>     halted
>   hw/net/xilinx_axienet: Fix packet double-buffering issue
> 
>  hw/dma/xilinx_axidma.c  | 249 +++++++++++++++++++++++++++++---------
> --
>  hw/net/xilinx_axienet.c |  12 ++
>  2 files changed, 193 insertions(+), 68 deletions(-)

Reply via email to