Jan Kiszka wrote: > Liran Schour wrote: >> Jan Kiszka <jan.kis...@siemens.com> wrote on 26/11/2009 15:53:49: >> >> >>>> + qemu_get_buffer(f, buf, >>>> + BLOCK_SIZE); >>>> + if(bs != NULL) { >>>> + >>>> + bdrv_write(bs, (addr >> SECTOR_BITS), >>>> + buf, block_mig_state->sectors_per_block); >>> This synchronous write-back translates appears to be the reason for an >>> unusable migration (or restore from snapshot) speed: about 100 KB/s here >>> (ie. 22h for a rather small 8G guest :( ). Did you already try to >>> improve this situation? >> I have seen this behavior, but it seems that there is a very big difference >> in the performance if the new block device is based on an allocated file >> already (try the same migration to an already allocated file in the >> requested size) I am trying to figure out why we see this behavior.(any >> ideas?) > > Yes, much faster, more than 6 MB/s. Not really impressing, but that's > now likely due to the tiny block size. > > That 4K also made the unallocated write so awfully slow as the image > file had to be continuously extended by this amount. > >> Anyway we can turn the writes to be async but we have to synchronize all >> destinations writes before completing the migration and moving the guest to >> the destination. When the guest starts to run on the destination all writes >> should be finished, so anyhow we need to wait synchronously to the writes. >> I will look on this further next week. > > Well, we actually need these changes: > 1. Reasonable block size (if we cannot overcome the cluster size, we > need to coalesce blocks on write out)
If I understood the logic correctly we can easily increase it during phase 2, ie. while in async mode. We just need to save the block size in its header if we vary it. > 2. Async write, throttled by the sync read, or both asynchronously. > Unfortunately, qemu's aio does not work yet at the point we need > it... > > I will also continue to dig into this. > > Jan > At this chance I realized that the length of the synchronous phase 3 depends on the number of dirty blocks collected during phase 2. Thus, the guest downtime will increase when it is under load, ie. typically at the point when the down-time must be minimal. We likely need an approach that takes the number of dirty sectors into account. Jan -- Siemens AG, Corporate Technology, CT T DE IT 1 Corporate Competence Center Embedded Linux