Hi Thomas, just exit like it is an error with a wrong option. the output is only this qemu-system-ppc64: KVM and IRQ_XICS capability must be present for in-kernel XICS Same is if i add all the options i have the seme error. look like qemu need for run in kvm a kernel with XICS option enabled and XICS is present only from ibm power 5 to up if i remember good. After work i can test it if needed on Qoriq e5500 too for check if there is the same issue on an emb ppc64 processor.
Ciao Luigi On 22.03.2017 14:35, luigiburdo wrote: > Hi Thomas with 2.9 rc1 i have this with --enable-kvm > > emu-system-ppc64 --enable-kvm > qemu-system-ppc64: KVM and IRQ_XICS capability must be present for in-kernel > XICS > > and the qemu dont run. Does it exit, or just hang afterwards? Was this with or without --device virtio-gpu-pci option? Do you get any output if you run QEMU with "-nographic" instead? Thomas -- You received this bug notification because you are a member of qemu- devel-ml, which is subscribed to QEMU. https://bugs.launchpad.net/bugs/1674925 Title: Qemu PPC64 kvm no display if --device virtio-gpu-pci is selected Status in QEMU: New Bug description: Hi, i did many tests on qemu 2.8 on my BE machines and i found an issue that i think was need to be reported Test Machines BE 970MP if i setup qemu with qemu-system-ppc64 -M 1024 --display sdl(or gtk),gl=on --device virtio- gpu-pci,virgl --enable-kvm and so and so result is doubled window one is vga other is virtio-gpu-pci without any start of the VM . pratically i dont have any output of openbios and on the virtual serial output the same issue i found is if i select: qemu-system-ppc64 -M 1024 --display gtk(or sdl) --device virtio-gpu-pci --enable-kvm and so and so i had been try to change all the -M types of all kind of pseries without any positive result. Ciao Luigi To manage notifications about this bug go to: https://bugs.launchpad.net/qemu/+bug/1674925/+subscriptions