On Fri, Apr 19, 2019 at 01:16:06PM +0200, Hannes Reinecke wrote: > On 4/15/19 12:35 PM, Yuval Shaia wrote: > > On Thu, Apr 11, 2019 at 07:02:15PM +0200, Cornelia Huck wrote: > > > On Thu, 11 Apr 2019 14:01:54 +0300 > > > Yuval Shaia <yuval.sh...@oracle.com> wrote: > > > > > > > Data center backends use more and more RDMA or RoCE devices and more and > > > > more software runs in virtualized environment. > > > > There is a need for a standard to enable RDMA/RoCE on Virtual Machines. > > > > > > > > Virtio is the optimal solution since is the de-facto para-virtualizaton > > > > technology and also because the Virtio specification > > > > allows Hardware Vendors to support Virtio protocol natively in order to > > > > achieve bare metal performance. > > > > > > > > This RFC is an effort to addresses challenges in defining the RDMA/RoCE > > > > Virtio Specification and a look forward on possible implementation > > > > techniques. > > > > > > > > Open issues/Todo list: > > > > List is huge, this is only start point of the project. > > > > Anyway, here is one example of item in the list: > > > > - Multi VirtQ: Every QP has two rings and every CQ has one. This means > > > > that > > > > in order to support for example 32K QPs we will need 64K VirtQ. Not > > > > sure > > > > that this is reasonable so one option is to have one for all and > > > > multiplex the traffic on it. This is not good approach as by design > > > > it > > > > introducing an optional starvation. Another approach would be multi > > > > queues and round-robin (for example) between them. > > > > > Typically there will be a one-to-one mapping between QPs and CPUs (on the > guest).
Er we are really overloading words here.. The typical expectation is that a 'RDMA QP' will have thousands and thousands of instances on a system. Most likely I think mapping 1:1 a virtio queue to a 'RDMA QP, CQ, SRQ, etc' is a bad idea... > However, I'm still curious about the overall intent of this driver. Where > would the I/O be routed _to_ ? > It's nice that we have a virtualized driver, but this driver is > intended to do I/O (even if it doesn't _do_ any I/O ATM :-) > And this I/O needs to be send to (and possibly received from) > something. As yet I have never heard of public RDMA HW that could be coupled to a virtio scheme. All HW defines their own queue ring buffer formats without standardization. > If so, wouldn't it be more efficient to use vfio, either by using SR-IOV or > by using virtio-mdev? Using PCI pass through means the guest has to have drivers for the device. A generic, perhaps slower, virtio path has some appeal in some cases. > If so, how would we route the I/O from one guest to the other? > Shared memory? Implementing a full-blown RDMA switch in qemu? RoCE rides over the existing ethernet switching layer quemu plugs into So if you built a shared memory, local host only, virtio-rdma then you'd probably run through the ethernet switch upon connection establishment to match the participating VMs. Jason
