Hi, Eric
On 2020/3/21 上午12:58, Eric Auger wrote:
Up to now vSMMUv3 has not been integrated with VFIO. VFIO
integration requires to program the physical IOMMU consistently
with the guest mappings. However, as opposed to VTD, SMMUv3 has
no "Caching Mode" which allows easy trapping of guest mappings.
This means the vSMMUV3 cannot use the same VFIO integration as VTD.
However SMMUv3 has 2 translation stages. This was devised with
virtualization use case in mind where stage 1 is "owned" by the
guest whereas the host uses stage 2 for VM isolation.
This series sets up this nested translation stage. It only works
if there is one physical SMMUv3 used along with QEMU vSMMUv3 (in
other words, it does not work if there is a physical SMMUv2).
- We force the host to use stage 2 instead of stage 1, when we
detect a vSMMUV3 is behind a VFIO device. For a VFIO device
without any virtual IOMMU, we still use stage 1 as many existing
SMMUs expect this behavior.
- We use PCIPASIDOps to propage guest stage1 config changes on
STE (Stream Table Entry) changes.
- We implement a specific UNMAP notifier that conveys guest
IOTLB invalidations to the host
- We register MSI IOVA/GPA bindings to the host so that this latter
can build a nested stage translation
- As the legacy MAP notifier is not called anymore, we must make
sure stage 2 mappings are set. This is achieved through another
prereg memory listener.
- Physical SMMU stage 1 related faults are reported to the guest
via en eventfd mechanism and exposed trhough a dedicated VFIO-PCI
region. Then they are reinjected into the guest.
Best Regards
Eric
This series can be found at:
https://github.com/eauger/qemu/tree/v4.2.0-2stage-rfcv6
Kernel Dependencies:
[1] [PATCH v10 00/11] SMMUv3 Nested Stage Setup (VFIO part)
[2] [PATCH v10 00/13] SMMUv3 Nested Stage Setup (IOMMU part)
branch at: https://github.com/eauger/linux/tree/will-arm-smmu-updates-2stage-v10
Really appreciated that you re-start this work.
I tested your branch and some update.
Guest: https://github.com/Linaro/linux-kernel-warpdrive/tree/sva-devel
<https://github.com/Linaro/linux-kernel-warpdrive/tree/sva-devel>
Host:
https://github.com/eauger/linux/tree/will-arm-smmu-updates-2stage-v10
<https://github.com/eauger/linux/tree/will-arm-smmu-updates-2stage-v10>
qemu: https://github.com/eauger/qemu/tree/v4.2.0-2stage-rfcv6
<https://github.com/eauger/qemu/tree/v4.2.0-2stage-rfcv6>
The guest I am using is contains Jean's sva patches.
Since currently they are many patch conflict, so use two different tree.
Result
No-sva mode works.
This mode, guest directly get physical address via ioctl.
While vSVA can not work, there are still much work to do.
I am trying to SVA mode, and it fails, so choose no-sva instead.
iommu_dev_enable_feature(parent, IOMMU_DEV_FEAT_SVA)
I am in debugging how to enable this.
Thanks