Similar to the SMBus io registers there is a power management io range that's set via similar base address reg and enable bit. Some handling of this was already there but with several problems: using the wrong registers and bits, wrong size range, not acually updating mapping and handling reset correctly or emulating any of the acrual io registers. Some of these are fixed up here.
After this patch we use the correct base address register, enable bit and region size and allow guests to map/unmap this region and correctly reset all registers to default values on reset but we still don't emulate any of the registers in this range. Previously just an empty RAM region was mapped on realize, now I've added empty io range logging access. I think the pm timer should be hooked up here but not sure guests need it. PMON on fuloong2e sets base address but does not seem to enable region; the pegasos2 firmware pokes some regs but continues anyway so don't know if anything would make use of these facilities. Therefore this is just a clean up of previous state for now and not intending to fully implement missing functionality which could be done later if some guests need it. Signed-off-by: BALATON Zoltan <bala...@eik.bme.hu> --- hw/isa/trace-events | 2 ++ hw/isa/vt82c686.c | 56 ++++++++++++++++++++++++++++++++------------- 2 files changed, 42 insertions(+), 16 deletions(-) diff --git a/hw/isa/trace-events b/hw/isa/trace-events index d267d3e652..641d69eedf 100644 --- a/hw/isa/trace-events +++ b/hw/isa/trace-events @@ -17,5 +17,7 @@ apm_io_write(uint8_t addr, uint8_t val) "write addr=0x%x val=0x%02x" # vt82c686.c via_isa_write(uint32_t addr, uint32_t val, int len) "addr 0x%x val 0x%x len 0x%x" via_pm_write(uint32_t addr, uint32_t val, int len) "addr 0x%x val 0x%x len 0x%x" +via_pm_io_read(uint32_t addr, uint32_t val, int len) "addr 0x%x val 0x%x len 0x%x" +via_pm_io_write(uint32_t addr, uint32_t val, int len) "addr 0x%x val 0x%x len 0x%x" via_superio_read(uint8_t addr, uint8_t val) "addr 0x%x val 0x%x" via_superio_write(uint8_t addr, uint32_t val) "addr 0x%x val 0x%x" diff --git a/hw/isa/vt82c686.c b/hw/isa/vt82c686.c index 9c4d153022..fc2a1f4430 100644 --- a/hw/isa/vt82c686.c +++ b/hw/isa/vt82c686.c @@ -39,14 +39,11 @@ struct VT686PMState { static void pm_io_space_update(VT686PMState *s) { - uint32_t pm_io_base; - - pm_io_base = pci_get_long(s->dev.config + 0x40); - pm_io_base &= 0xffc0; + uint32_t pmbase = pci_get_long(s->dev.config + 0x48) & 0xff80UL; memory_region_transaction_begin(); - memory_region_set_enabled(&s->io, s->dev.config[0x80] & 1); - memory_region_set_address(&s->io, pm_io_base); + memory_region_set_address(&s->io, pmbase); + memory_region_set_enabled(&s->io, s->dev.config[0x41] & BIT(7)); memory_region_transaction_commit(); } @@ -92,6 +89,13 @@ static void pm_write_config(PCIDevice *d, uint32_t addr, uint32_t val, int len) trace_via_pm_write(addr, val, len); pci_default_write_config(d, addr, val, len); + if (ranges_overlap(addr, len, 0x48, 4)) { + uint32_t v = pci_get_long(s->dev.config + 0x48); + pci_set_long(s->dev.config + 0x48, (v & 0xff80UL) | 1); + } + if (range_covers_byte(addr, len, 0x41)) { + pm_io_space_update(s); + } if (ranges_overlap(addr, len, 0x90, 4)) { uint32_t v = pci_get_long(s->dev.config + 0x90); pci_set_long(s->dev.config + 0x90, (v & 0xfff0UL) | 1); @@ -102,6 +106,27 @@ static void pm_write_config(PCIDevice *d, uint32_t addr, uint32_t val, int len) } } +static void pm_io_write(void *op, hwaddr addr, uint64_t data, unsigned size) +{ + trace_via_pm_io_write(addr, data, size); +} + +static uint64_t pm_io_read(void *op, hwaddr addr, unsigned size) +{ + trace_via_pm_io_read(addr, 0, size); + return 0; +} + +static const MemoryRegionOps pm_io_ops = { + .read = pm_io_read, + .write = pm_io_write, + .endianness = DEVICE_NATIVE_ENDIAN, + .impl = { + .min_access_size = 1, + .max_access_size = 1, + }, +}; + static void pm_update_sci(VT686PMState *s) { int sci_level, pmsts; @@ -128,35 +153,34 @@ static void vt82c686b_pm_reset(DeviceState *d) { VT686PMState *s = VT82C686B_PM(d); + memset(s->dev.config + PCI_CONFIG_HEADER_SIZE, 0, + PCI_CONFIG_SPACE_SIZE - PCI_CONFIG_HEADER_SIZE); + /* Power Management IO base */ + pci_set_long(s->dev.config + 0x48, 1); /* SMBus IO base */ pci_set_long(s->dev.config + 0x90, 1); - s->dev.config[0xd2] = 0; + pm_io_space_update(s); smb_io_space_update(s); } static void vt82c686b_pm_realize(PCIDevice *dev, Error **errp) { VT686PMState *s = VT82C686B_PM(dev); - uint8_t *pci_conf; - pci_conf = s->dev.config; - pci_set_word(pci_conf + PCI_COMMAND, 0); - pci_set_word(pci_conf + PCI_STATUS, PCI_STATUS_FAST_BACK | + pci_set_word(dev->config + PCI_STATUS, PCI_STATUS_FAST_BACK | PCI_STATUS_DEVSEL_MEDIUM); - /* 0x48-0x4B is Power Management I/O Base */ - pci_set_long(pci_conf + 0x48, 0x00000001); - pm_smbus_init(DEVICE(s), &s->smb, false); memory_region_add_subregion(pci_address_space_io(dev), 0, &s->smb.io); memory_region_set_enabled(&s->smb.io, false); apm_init(dev, &s->apm, NULL, s); - memory_region_init(&s->io, OBJECT(dev), "vt82c686-pm", 64); + memory_region_init_io(&s->io, OBJECT(dev), &pm_io_ops, s, + "vt82c686-pm", 0x100); + memory_region_add_subregion(pci_address_space_io(dev), 0, &s->io); memory_region_set_enabled(&s->io, false); - memory_region_add_subregion(get_system_io(), 0, &s->io); acpi_pm_tmr_init(&s->ar, pm_tmr_timer, &s->io); acpi_pm1_evt_init(&s->ar, pm_tmr_timer, &s->io); -- 2.21.3