Hi again, > On Tue, 6 Nov 2018 at 09:23, Matthias Kuhn <[email protected]> wrote: > With the initial release there was an issue that the checks were only enabled > if the project was saved and reloaded. Meanwhile this has been fixed and the > checks can be activated and will take effect immediately (with the next patch > release 3.4.2 or any nightly build until then).
After upgrading my installation to 3.4.2 (Win10) I tried the feature again and run into the following problem: I have a layer open (tested with *.shp *.gpkg and PostGIS), set the desired digitizing setting in the layer-options and forcefully add a topological error. What then happens is that the validation finds the error, therefore the layer can not be saved, but the panel does not open. The log messages say: - 2018-12-03T11:06:33 INFO Geometry Validation : Running geometry validation checks before saving… - 2018-12-03T11:06:37 WARNING Could not save changes. Geometry validation failed. Am I missing any prerequisite which is necessary? I tested on fresh layers/projects. Cheers _______________________________________________ Qgis-user mailing list [email protected] List info: https://lists.osgeo.org/mailman/listinfo/qgis-user Unsubscribe: https://lists.osgeo.org/mailman/listinfo/qgis-user
