Oh yeah, it works fine now. On Tue, Sep 03, 2002 at 11:33:04AM -0400, Gene Parks wrote: > I had the same problem. Just didn't have time to figure out why it was looking up >the wrong attribute. > > Have you tried the change to see if it corrects it? > > Gene > > -----Original Message----- > From: Brendon Colby [mailto:[EMAIL PROTECTED]] > Sent: Tuesday, September 03, 2002 11:13 AM > To: [EMAIL PROTECTED] > Subject: Typo? > > > In QLDAPINSTALL: > > -DUSE_RFC822 > The differences are that while the default QmailLDAP behaviour > uses the following attributes > mail Store the mail address > mailForwardingAddress Where to send mail > > The RFC822 says to use the following attributes instead: > mailLocalAddress Store the mail address > mailRoutingAddress Where to send mail > > In qmail-ldap.h: > > #ifndef USE_RFC822 > # define LDAP_MAIL "mailLocalAddress" > # define LDAP_FORWARDS "mailRoutingAddress" > #else > > Shouldn't that be "#ifdef USE_RFC822"? > > I use the mail attribute. I therefore did not define USE_RFC822. This broke > my installation as qmail-ldap was searching on the mailLocalAddress > attribute. > > This is using the newest qmail-ldap release by the way. > > > -- > Brendon Colby > Systems Administrator > Midcontinent Communications
-- Brendon Colby Systems Administrator Midcontinent Communications
