Hi all,
Could you please let me know PBR (Policy Based Routing) functionality support is present in Quagga for both Static routes and Dynamic routing cases or not. I am able to see the configuration option to configure the route-map config, but the next hop was not modified. Below is my config for static case, Please correct me if I missed any config. Before applying the PBR config, route table info K>* 0.0.0.0/0 via 10.200.8.1,vmmgmt K>* 1.0.0.0/24 via 2.0.0.1, enp2s0f3 C>* 2.0.0.0/24 is directly connected, enp2s0f3 C>* 3.0.0.0/24 is directly connected, enp2s0f1 C>* 10.200.8.0/24 is directly connected, vmmgmt S>* 25.25.0.0/24 [1/0] via 2.0.0.20, enp2s0f3 S>* 30.0.0.0/24 [1/0] via 3.0.0.40, enp2s0f1 Tried configuring PBR below two ways 1. Using access list access-list anki permit 25.25.0.0/24 ! route-map qwe permit 5 match ip address anki set ip next-hop 3.0.0.40 1. Directly applying matching ip route-map aaa permit 2 match ip address 25.25.0.0/24 set ip next-hop 3.0.0.40 Note: I am not seeing any configuration support to apply the PBR config under interface. After applying the above config , show ip route in Quagga displays the same output, next hop was not modified. K>* 1.0.0.0/24 via 2.0.0.1, enp2s0f3 C>* 2.0.0.0/24 is directly connected, enp2s0f3 C>* 3.0.0.0/24 is directly connected, enp2s0f1 C>* 10.200.8.0/24 is directly connected, vmmgmt S>* 25.25.0.0/24 [1/0] via 2.0.0.20, enp2s0f3 S>* 30.0.0.0/24 [1/0] via 3.0.0.40, enp2s0f1 C>* 127.0.0.0/8 is directly connected, lo C>* 192.168.122.0/24 is directly connected, virbr0 Thanks a lot for your help in advance. Thanks, Anki
_______________________________________________ Quagga-dev mailing list [email protected] https://lists.quagga.net/mailman/listinfo/quagga-dev
