After over 17 years of having an intermittent fault on the ignition wire, I Finally got around to looking at it this week as it was becoming a right pain in the backside!
I unwrapped 18” of the wire back to where it joins up with the rest of the loom. About half way along I found some gaffer tape......... Under the tape was a Really bad bodged join. Two bare wires had been put next to each other and crimped/squashed together, then wrapped in gaffer tape. No solder, no heatshink, no nothing, except hope.....! I have now replaced it with a length of new wire (properly joined). It works now Chris G -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to quantumowners@googlegroups.com To unsubscribe from this group, send email to quantumowners-unsubscr...@googlegroups.com For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to quantumowners+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.