On Thu, Dec 6, 2018 at 3:52 PM Jonathan Proulx <j...@jonproulx.com> wrote: > > Hi All, > > New to Qubes so hopefully I just missed some thing obvious. When > resuming from suspend on Lenovo X1 Carbon (gen3) with fresh Qubes 4.0 > install I'm loosing access to the physical disk on resume.
With a few clever suggestions from ThomasWaldmann and busu on IRC I've gotten a bit more detail but no resolution yet. copying binaries and libraries to /tmp before suspend keeps them usable on resume. dmesg shows additional messages that were't making it to the console: ata1: SATA link up 6.0 Gbps (SStatus 133 SControl 300 ) ata1.00: qc timeout (cmd 0xec) ata1.00: failed to IDENTIFY (I/O error, err mask=0x4) ata1.00: revalidation failed (errno=-5) ata1: SATA link up 6.0 Gbps (SStatus 133 SControl 300 ) ata1.00: qc timeout (cmd 0xec) ata1.00: failed to IDENTIFY (I/O error, err mask=0x4) ata1.00: revalidation failed (errno=-5) ata1: limiting SATA link speed to 3.0 Gbps ata1: SATA link sown (SStatus 0 SControl 320 ) ata1.00: disabled sd 0:0:0:0: rejecting I/O to off line device <etc...> reverting from 4.14.74 to the default 4.14.18 kernel doesn't change anything echo "- - -" > /sys/class/scsi_host/host0/scan does show bus reset in dmesg but doesn't rediscover the lost drive rescan-scsi-bus.sh from sg3_utils (after much copying of dependencies to tmpfs) executes and scans host0 but finds zero drives post resume smartctl shows drive healthy and long selftest passed with no logged errors in device lifetime and all counter at the good end of their scales. X1 is a fairly popular laptop and gen3's been a round a while so I tend to suspect this is a setting on my side rather than a Qubes bug especially as I was running a different linux 4.18 kernel on this hardware recently, but not sure what else there is to poke. The most obvious bios setting is the Intel Rapid Start which was "on" though that should only take effect after 30min and my failures are immediate so unsurprisingly switching this to "off" has no effect either. Thanks, -Jon -- You received this message because you are subscribed to the Google Groups "qubes-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to qubes-users+unsubscr...@googlegroups.com. To post to this group, send email to qubes-users@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/qubes-users/CABZB-shMQxM_wvOFMhOn76Y7emmq9kSDiga%3DQPXn5SeKNAsiSw%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.