Torsten Krieger wrote:
Hi folks,
I have a problem with NTP server version 4.2.2p3 and my embedded Linux
system FOX Board. I'am using a raw dcf77 receiver from Sure, the receiver is
working fine with my Linux PC but not with my embedded system. I found that
parity check is disable on the Linux PC but not on my embedded system, so I
have also disabled the parity check on the Fox Board, which than results to
the following ERRORS seen in the log file:
ntpd[83]: parse: convert_rawdcf: parity check FAILED for
"-###----#--#--#-----S-------P-2----P-2--12-241-4-1---8---8p"
unlurk.
is that one of the receivers were the serial line receives the raw puls
with ~50baud and reads the 0.1s (L) pulse as 'x' and the 0.2s (H) pulse
as 'p' or there abouts?
if yes: is your line sense ok? i.e. is there a (inverting) rs232 receiver in
front
of RXD or not.
(where) Have you disabled parity check inside ntpd?
Any idea what is going wrong!
Many thanks in advanced,
Torsten
_______________________________________________
questions mailing list
[email protected]
https://lists.ntp.isc.org/mailman/listinfo/questions
uwe
_______________________________________________
questions mailing list
[email protected]
https://lists.ntp.isc.org/mailman/listinfo/questions
