John Oliver <[EMAIL PROTECTED]> writes: >On Wed, 02 Apr 2008 09:58:38 +0200, Martin Burnicki wrote: >> What's the output of: >> >> date -u; date
>[EMAIL PROTECTED] ~]# date -u; date >Wed Apr 2 20:29:25 UTC 2008 >Wed Apr 2 20:29:25 GMT 2008 >>> [EMAIL PROTECTED] ~]$ /sbin/hwclock >>> Tue 01 Apr 2008 09:05:39 PM GMT -0.323329 seconds >>> [EMAIL PROTECTED] ~]$ sudo /sbin/hwclock --systohc >>> [EMAIL PROTECTED] ~]$ /sbin/hwclock >>> Tue 01 Apr 2008 09:05:52 PM GMT -0.776568 seconds >> >> Normally the system time is only initialized from the hwclock (the RTC chip >> on the mainboard) at boot time, and when the system shuts down properely >> the current system time should be written back to the hwclock. In most >> cases you see this in the console messages. >> >> If you have a dual/multi boot system then you must take care that all >> operating systems assume the RTC to run at the same time, i.e. either local >> time or UTC. >There is only one OS on the host(s) in question. Good-- information not available to us. >> If the system is Linux only I'd suggest you configure your Linux system such >> that the RTC chip keeps UTC time only. If then the time is not correct >> after a reboot your on-board battery may be low. >There are no reboots. The above example is one command after another... >read the hwclock, set it from the system time, and then immediately read >it again. I don't see how this could be a hardware issue, unless this >chip is specifically programmed to always add/subtract 12 hours from the >time it's set to, which I rather doubt :-) cat /etc/sysconfig/clock and post the output here. Anyway, none of this has anything to do with ntp at all. It would be best to go to a Linux group for your particular distribution. >-- >* John Oliver http://www.john-oliver.net/ * >-- >Posted via a free Usenet account from http://www.teranews.com _______________________________________________ questions mailing list questions@lists.ntp.org https://lists.ntp.org/mailman/listinfo/questions