You can use "show config merged" to see the local device's config merged with the templates from Panorama.
On Thu, Jul 11, 2019 at 02:19:00PM +0000, Gauthier, Chris wrote: > I have run into the issues seen below, as we migrated to a fully-managed > Panorama ecosystem in recent months. The output of the “show configuration > running” (or whatever it is) is more limited on the managed device because (I > believe) what is being shown is only the locally-managed configuration. I > haven’t looked yet to see if there is a workaround. > > --Chris > > > Chris Gauthier Senior Network Engineer | Comscore > t +1 (503) 331-2704 | > cgauth...@comscore.com > comscore.com > This e-mail (including any attachments) may contain information that is > private, confidential, or protected by attorney-client or other privilege. If > you received this e-mail in error, please delete it from your system and > notify sender. > From: Rancid-discuss <rancid-discuss-boun...@shrubbery.net> on behalf of > annie lee <lsy.an...@gmail.com> > Date: Wednesday, July 10, 2019 at 6:02 PM > To: john heasley <h...@shrubbery.net> > Cc: "rancid-discuss@shrubbery.net" <rancid-discuss@shrubbery.net> > Subject: Re: [rancid] Palo Alto (Panorama) configuration > > i tried to grab the configs from the panorama and it's what i wanted :-) > apology, im pretty new to the paloalto and panorama device/setup. > > thanks and glad i can backup the palo/panorama configs without any tweaking. > > On Thu, Jul 11, 2019 at 9:23 AM annie lee > <lsy.an...@gmail.com<mailto:lsy.an...@gmail.com>> wrote: > Hi John, > > Thanks for your reply and apology for the typo on the paloalto type. > (1.1.1.1;paloalto;up) > Below are the sample config for one of the firewall configs (removed all the > ip addresses). > Basically there are heaps more configs (routing, policy, NAT, virtual router > and etc...) i can see from the Panorama. > Not sure its similar to F5 tweak that we need to add the partition to grab > the full configs. > > Rgds > > On Thu, Jul 11, 2019 at 7:42 AM john heasley > <h...@shrubbery.net<mailto:h...@shrubbery.net>> wrote: > Wed, Jul 10, 2019 at 11:53:42AM +1000, annie lee: > > Hi All, > > > > Another question, just added a new PaloAlto to rancid (3.9) but not much > > configurations being backup (not even interfaces addresses) > > Anything need to be changed/added to backup the entire configuration ? > > > > 1.1.1.1;palo-alto;up > > Please use the built-in type for PAN: paloalto. if that is still lacking, > please be more specific about what commands are missing. it collects > > show system info;show chassis inventory;show config running _______________________________________________ Rancid-discuss mailing list Rancid-discuss@shrubbery.net http://www.shrubbery.net/mailman/listinfo/rancid-discuss