Hello Bruce, I have not used R:Base for a while so I am a little rusty…make that, very rusty.
I believe there are several commands that might help: You can set “No break on error” from the top menu. (CTRL + F5) You can do an “Execute to error” From the top menu. (SHIFT + F10) You can also add breakpoint at strategic locations and then run to breakpoint, this should allow you to pinpoint the location and when you are close, go one line at a time until you find the culprit code. My code, including forms and reports usually have this line at the top: DEBUG SET TRACE ON And a matching DEBUG SET TRACE OFF at the bottom. Now, If I SET DEBUG ON, everything in the code with command above runs in TRACE mode. This is great when testing code. When done, I SET DEBUG OFF and code runs normally. Hopefully the above gives you some clues. Javier, Javier Valencia, PE 14315 S Twilight Ln Olathe, KS 66062 913-915-3137 From: [email protected] <[email protected]> On Behalf Of Bruce Chitiea Sent: Sunday, June 15, 2025 5:16 PM To: [email protected] Subject: [RBASE-L] - TRACE Setting? RBG11 06/12/25 Is there a TRACE setting which will prevent an automatic exit from TRACE when a simple variable datatype error is encountered? By exiting, there's no report on where the error occurs, rendering Execute-to-Error [Shift-F10] of no use, as it forces an [F10] slog through the code file. Thoughts? Bruce A. Chitiea SafeSectors, Inc. 1142 S Diamond Bar Blvd # 442 Diamond Bar CA 91765-2203 [email protected] <mailto:[email protected]> (909) 238-9012 m -- For group guidelines, visit http://www.rbase.com/support/usersgroup_guidelines.php --- You received this message because you are subscribed to the Google Groups "RBASE-L" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected] <mailto:[email protected]> . To view this discussion visit https://groups.google.com/d/msgid/rbase-l/emd6aaccec-333e-45e8-b64c-6131bfb6fd09%40829c55c8.com <https://groups.google.com/d/msgid/rbase-l/emd6aaccec-333e-45e8-b64c-6131bfb6fd09%40829c55c8.com?utm_medium=email&utm_source=footer> . -- For group guidelines, visit http://www.rbase.com/support/usersgroup_guidelines.php --- You received this message because you are subscribed to the Google Groups "RBASE-L" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion visit https://groups.google.com/d/msgid/rbase-l/027901dbdf1a%244705d570%24d5118050%24%40vtgonline.com.
