Check for a variable used in your report that is also used in your application. I believe the variable will not be cleared even if "clear variables after report" is checked.
Regards, Stephen Markson ForenSys The Forensic Systems Group www.ForenSys.ca <http://www.forensys.ca/> 416 512 6950 _____ From: [email protected] [mailto:[email protected]] On Behalf Of Alastair Burr Sent: January 19, 2009 11:21 AM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Continuing problems with empty reports. Larry, Do you have in your print command any OPTIONs such as SHOW_CANCEL_DIALOG OFF? If so, try your print without them - I have a report that causes me a problem with that particular option which I believe to be caused by the gross amount of data produced - ie the opposite of yours. It may be way off beam but it might be worth a try. Regards, Alastair. ----- Original Message ----- From: Lawrence <mailto:[email protected]> Lustig To: RBASE-L Mailing List <mailto:[email protected]> Sent: Monday, January 19, 2009 3:48 PM Subject: [RBASE-L] - Re: Continuing problems with empty reports. .I'm sure this must be something I'm doing - not clearing variables, not closing some programming structure, or something. But no errors are generated, and after you start R:Base it seems to be a very random period of time and set of operations before the problem is seen. Sometimes right away, sometimes not at all, sometimes after a few hours. . . -- Larry _____ No virus found in this incoming message. Checked by AVG - http://www.avg.com Version: 8.0.176 / Virus Database: 270.10.9/1900 - Release Date: 18/01/2009 12:11 No virus found in this incoming message. Checked by AVG - http://www.avg.com Version: 8.0.176 / Virus Database: 270.10.9/1900 - Release Date: 1/19/2009 9:37 AM
