Thanks, Razzak !
--------------------------------------------------
From: "A. Razzak Memon" <[email protected]>
Sent: Sunday, August 08, 2010 4:04 PM
To: "RBASE-L Mailing List" <[email protected]>
Subject: [RBASE-L] - re: activation trouble
At 09:05 AM 8/8/2010, Luc Delcoigne wrote:
- installation of rbase90 goes well.
- after installation of the latest update each time I start rbase
I have to retype the license key.
How can I prevent this ??
Luc,
Here's how:
01. Make sure that R:BASE eXtreme 9.0 has been installed when an
Administrator was logged onto the computer. Then make sure
the latest update is applied. http://www.rupdates.com
02. If you are using the Windows 7 x64 operating system, then check
the registry to verify the following entry exists:
HKEY_LOCAL_MACHINE\SOFTWARE\Wow6432Node\R:BASE Technologies\RBG90
If you are using the x32 operating system, check the registry to
verify the following entry exists:
HKEY_LOCAL_MACHINE\SOFTWARE\R:BASE Technologies\RBG90
03. Then, assign the required Read, Write, Full Control permissions
to all users so that the values can be identified by R:BASE. You
would do so by right clicking on the RBG90 entry and selecting
"Permissions" from the menu.
04. Finally, for the Windows Vista or later operating systems where
User Access Control will be enabled for notifications at any
degree, the License Key entry and product activation must be
performed while the end user is logged on, not the Administrator.
At this point, the License Key will be entered and the activation
process completed.
That's all there is to it!
Very Best R:egards,
Razzak.
P.S. The above instructions are also made available in the R:BASE
eXtreme 9.0 Getting Started Guide.
Section 2.7 Permissions (Page 19-20)
\RBTI\RBG90_32\RBASEeXtreme32forWindows_GettingStartedGuide.pdf
\RBTI\RBG90_64\RBASEeXtreme64forWindows_GettingStartedGuide.pdf
