No I haven't I will try it with V8 and see what happens. I won't be able to do that until tomorrow I'll report back my results.
Gary From: [email protected] [mailto:[email protected]] On Behalf Of jan johansen Sent: Friday, August 13, 2010 3:28 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Importing Tab Delimited File Gary, Have you tried the same sequence in 7.6 or V8? If it works in either of them, then it may be possible that there is something to be worked on in V8 Extreme. I have not had any problems using Gateway but my import files have been smaller. Jan -----Original Message----- From: "Gary Randall" <[email protected]> To: [email protected] (RBASE-L Mailing List) Date: Fri, 13 Aug 2010 15:13:02 -0700 Subject: [RBASE-L] - Importing Tab Delimited File Hello All, I am running Rbase 9.0 (64) I trying to use file gateway to load a Tab Delimited File (txt) to an existing table. Using the Import Wizard I get to the Screen where you tell Rbase to start importing at row number: after I press the next button the program acts like its searching, nothing else happens. I have tried this several times and get the same results, I even let it run all night and nothing happen. If I try to close out of the File Gateway Import Wizard I get a Rbase not responding error and have to force shut down. The file I am trying to import is 677,641 KBs and has 3,563,000 rows of data. I have checked the table and it is ok the rows are all there. I have even tried importing to a NEW TABLE but get the very same results. I have done the import using access and it worked fine, I know Rbase is not going to be out done by off the shelf access, so my question is what am I doing wrong? Thanks Gary
