Thanks Steve,I had forgotten that it is in the control panel and I did not specify a log file. Now that I did, and inspecting the log file, I am overwhelmed. Too much info!!
----- Original Message ----- From: "Steve Vellella" <[email protected]>
To: "RBASE-L Mailing List" <[email protected]> Sent: Thursday, November 11, 2010 8:38 PM Subject: [RBASE-L] - Re: RMail Whoops! Bernie,In the RMAIL setup in the control panel you turn on the log file and you can also set it to display messages during the send so that you can see if it is working properly. And yes "S" means it sent. "N" means it did not.
Steve Steve Vellella Office: 520-498-2256 Cell: 520-250-6498 -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Bernard Lis Sent: Thursday, November 11, 2010 6:29 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: RMail Whoops!----- Original Message ----- From: "Bernard Lis" <[email protected]>
To: "RBASE-L Mailing List" <[email protected]> Sent: Thursday, November 11, 2010 8:23 PM Subject: [RBASE-L] - RMail
SET VAR vSendMail = (UDF('@RMail.DLL','MessageFile.mal'))
I meant to say: vSendMail = S not Y
If the value of vSendMail is Y does that mean it was sent ok? if = N does that mean it was not sent? If not sent, is there a way to determine why it was not sent? Bernie Lis
