I use PRNSETUP with a dotted variable. It doesn't like ampersands.
Albert
On 27/07/2014 4:42 PM, MikeB wrote:
That shouldn't help any since the variable is a value and not a redirection
(command or command sequence)
-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Buddy
Walker
Sent: Sunday, July 27, 2014 6:02 PM
To: RBASE-L Mailing List
Subject: [RBASE-L] - RE: Prnsetup
Tom
You could try using an ampersand instead of the dot.
Show your variable at the R: Prompt and then try to manually execute
the prnsetup by
Typing PRNSETUP and then whatever you variable shows.
Buddy
From: [email protected] [mailto:[email protected]] On Behalf Of TOM
HART
Sent: Sunday, July 27, 2014 9:49 AM
To: RBASE-L Mailing List
Subject: [RBASE-L] - Prnsetup
I used this command for years
prnsetup .vprinter1
print mystuff
prnsetup .vprinter2
then do whatever
var vprinter1 and 2 are a label printer and a receipt printer
This has worked for years until the last update, now it works as
expected to print mystuff, but after it prints the
printsetup pops up again. It happens anywhere I use this. I tried
taking out the second prnsetup but same thing
Tom Hart
