The settings look normal. I tried to edit the data using a PC with an older version of RBase from April 2013 and that version could edit the data from the R>
From: [email protected] [mailto:[email protected]] On Behalf Of Buddy Walker Sent: Friday, February 13, 2015 4:47 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Not able to edit data from R> Are you trying to change a date field, if so what is your default date. I would check IDQuotes and quotes to make sure everything is ok. This would include NULL setting. From: [email protected] [mailto:[email protected]] On Behalf Of Bill Niehaus Sent: Friday, February 13, 2015 5:33 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Not able to edit data from R> There is a primary key which is on a column that is not null and is not being edited. I reloaded the database which did not change the results. From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Buddy Walker Sent: Friday, February 13, 2015 4:25 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Not able to edit data from R> Do you have any rules or primary/foreign keys set up on the table. If not, I would reload/pack the database. Then try you may have a corrupted index From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Bill Niehaus Sent: Friday, February 13, 2015 4:41 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Not able to edit data from R> I can edit data for a row, but can not exit the row of data until I use F5 to reset the data. From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Carpet Broker, Dick Fey Sent: Friday, February 13, 2015 3:37 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Not able to edit data from R> Edit all FROM tablename where.............................. Dick Fey Carpet Broker Inc. On 2/13/2015 3:26 PM, Bill Niehaus wrote: In the past, I could use a command like: EDIT ALL IN tablename WHERE PLANTYEAR = ‘2015’ I could edit data that was not setup to be edited through the normal application menus. Now I can not seem to edit data using this command. Is there a setting that could be impacting this command? I’m guessing this started to show up in January. Thanks. Bill Niehaus
