Bill,
Under the report designer, variables, there is a selection to change the section that
a variable is assigned to. Make sure that you have assigned the variables located in
each section to that section. The only time that this does not apply is if it is a
summation or count - those variables should remain assigned to the detail section.
Regards,
Steve Vellella
Bill Niehaus wrote:
> I am converting a DOS application to RB Win 2000 and have a report which prints out
>the correct information in DOS. The report uses sections H1, D and F2 on the report.
> The DOS version is setup where the variables are not reset at the break points.
>
> When I try to us the Windows version with a converted report, a variable located in
>the Header1 section fails to print. If the variable is moved to the Footer2 section,
>it prints the correct information.
>
> There are two break points in the report based upon the same column in the driving
>table.
>
> Are my break points causing this problem?
>
> Thanks.
>
> Bill Niehaus
