Larry, I tried your test in ConComp. Emmit - did you print yours to the printer to see if it printed where it was supposed to? That's the issue. When printing to the screen or using preview from within design mode, the rotated label prints where expected. When printing to the printer, it prints higher up on the page. Are we missing a setting or should this be reported to rbdcc? Dawn
-----Original Message----- From: Lawrence Lustig [mailto:[EMAIL PROTECTED] Sent: Friday, June 25, 2004 1:38 PM To: RBG7-L Mailing List Subject: [RBG7-L] - Re: Fwd: Re: [RBG7-L] - Re: Page Style label moves > 1. The rotated label was centered vertically and horizontally in the > page style band Do you mean manually centered, or sized to be the same as teh page style band and then centered by the program? Here are the steps I used to duplicate my problem in ConComp (if you care to spend any more time on it): Open RRBYW8, and open the PageStyleReport in Design mode. In the Page Style band of the report, locate a Rotated Label component. Set the following properties: Angle = 20 degrees Font = Arial 72 point Text = Test Label Now, move the label so that the highest visible point (the top of the final letter L in "LabeL") is at the same height as the "E" in the R:Base graphic logo on the page. Now, switch to Preview mode. The report will appear correctly on the screen -- the label and the word R:Base are at the same height. Now print the report (you only need to print the current page). The label will now move up on the printed version, so the top of the label is about an inch or two above the R:Base logo. It appears that the difference may be due to the height of the header. -- Larry
