https://tumbleweed.cc/collections/products/products/t-rack
They also have the adapter for the fender mount that was mentioned earlier, On Saturday, January 27, 2024 at 11:33:34 PM UTC-5 Pam Bikes wrote: > Thanks all for your collective wisdom. I looked at it again and don't > think it would work either. And the R50 won't help much since I need help > on the bottom. I'll try Steve's coroplast idea to see if that helps. I > was trying to just have one big bag on this bike. But when I carry stuff > it gets heavy and sags. I may add the coroplast and out a front bag on or > just make sure I'm w/someone else w/more carrying capacity. > > I never have a problem carrying stuff on my Betty. I'm so used to having > 2 big bags and a rear rack. And then the sky is the limit literally. That > and the 50 lb weight limit of the rack or whatever it's supposed to be. > But I won't go far with that much weight anyway. > > On Saturday, January 27, 2024 at 3:18:12 PM UTC-5 krhe...@gmail.com wrote: > >> Here is a link to a Nitto R50 Andrews Bag Holder: >> >> https://www.somafabshop.com/shop/18670-nitto-r50-andrews-bag-holder-rivendell-3797#attr= >> >> There is only one available LEFT ! ! ! >> >> Kim Hetzel. >> >> On Saturday, January 27, 2024 at 7:05:19 AM UTC-8 Brian Turner wrote: >> >>> Pam, unfortunately your combination of chunky seatpost binder, >>> old-school seatpin and sandwich clamp, and the springs on your saddle >>> aren't doing you any favors in regards to freeing up what already limited >>> space you have. I seriously doubt the clamp for the R10 will find space on >>> your post. And, as others have mentioned, the design of the R10 would >>> likely dip down too far to avoid interfering with your wheel. It's a shame >>> there are no other braze-ons along the length of your seat stays. One >>> option may be to find a small rack like a Nitto Mark's rack, and see if you >>> can find rack struts long enough to reach down to the rear dropouts, and >>> then either fashion a diving board to the brake bridge (where you have your >>> fender clip mounted), or use another set of rack struts with p-clamps >>> around your seat stays. >>> >>> Brian >>> Lex KY >>> >>> On Saturday, January 27, 2024 at 9:56:20 AM UTC-5 Steve wrote: >>> >>>> Pam, you might try a trick I've used to stiffen the bag enough to >>>> prevent sagging. Get your hands on a sheet of corrugated plastic - the >>>> same >>>> stuff that is used for political campaign yard signs (they should soon be >>>> readily available for no cost ; ) >>>> >>>> Cut the plastic sheet to fit the interior width of the bag and long >>>> enough to cover the bottom and extend up onto the front wall of the bag. >>>> The corrugations need to run across the width of the cut sheet so you can >>>> fold it to curve up the front wall. The sheet should be sized to fit >>>> slightly snug to prevent it shifting around inside the bag. It's a low >>>> cost, light weight solution that repurposes bit of plastic that is >>>> otherwise destined for the land fill. >>>> >>>> Your Schwinn looks like a sweet little bike in its own right. >>>> >>>> Steve in Asheville >>>> >>>> On Saturday, January 27, 2024 at 12:43:31 AM UTC-5 Pam Bikes wrote: >>>> >>>>> Thinking about getting a R10 as a bag support - for a small Fab's >>>>> Chest. This is on my back up Schwinn. I set it up just like my Betty >>>>> Foy >>>>> in case I ever need any parts. Concerns are that I have a 26.6 seatpost >>>>> and it says 26.8. I guess I could get a shim. Would it hold? How much >>>>> is >>>>> the weight limit for the rack? And I'm not sure if I have enough seat >>>>> post >>>>> to put the clamp. Right now, I have the pec dec but if I put too much in >>>>> the bag, it starts to sag and I don't want it dragging on the tire. >>>> >>>> -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to rbw-owners-bunch+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/rbw-owners-bunch/dd509775-a4ab-4f84-9124-7a0186f0cc5en%40googlegroups.com.
