It's not labeled as a HZ, but I'll recommend the Mike Plumpatire floor pump here. It puts out enough volume that I used it for my motorcycle tires rather than dragging the compressor out :)
Eric On Sun, May 11, 2025 at 12:46 PM Berkeleyan <[email protected]> wrote: > This past week, I used the H-Z freewheel tool on my 28-year-old Sachs rear > 6-sp freewheel, and a NOS Sachs 7-sp unit (thanks, pastor Bob). It wouldn't > fit very deep at all, so I centered it on the lathe and removed a very > small amount from the outer surface of the splines, less than a thousandth > of an inch from the diameter, and then it slipped right in, fully- and > wholly-engaged. > > - Andrew, Berkeley > On Thursday, March 14, 2024 at 9:12:56 PM UTC-7 [email protected] wrote: > >> Looking for recommendations for any HZ tools that you have tried and >> would recommend... >> >> Thank you >> peter >> > -- > You received this message because you are subscribed to the Google Groups > "RBW Owners Bunch" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion visit > https://groups.google.com/d/msgid/rbw-owners-bunch/6f99a684-3916-4e4e-a5e4-9e6c545a44cbn%40googlegroups.com > <https://groups.google.com/d/msgid/rbw-owners-bunch/6f99a684-3916-4e4e-a5e4-9e6c545a44cbn%40googlegroups.com?utm_medium=email&utm_source=footer> > . > -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion visit https://groups.google.com/d/msgid/rbw-owners-bunch/CAHFNW5AJGUop8w8MLKWzUaXj%3DPir2J5b%2BT4ob2jxVwv20wsNaA%40mail.gmail.com.
