Sounds like your dead zone is to small. I think Frank put a adjust to make it larger.
Will -----Original Message----- From: Cold comfort <[EMAIL PROTECTED]> To: R/C Tank Combat <[email protected]> Sent: Sun, 14 Sep 2008 5:05 pm Subject: [TANKS] Static? I have been testing my motors and track with a sabertooth dual speed controller and C6C. Running the track up off the floor for a bit then stopping I hear a sound similar to static electricity emanating from the tracks, also after running the tracks in all directions after a short time I seem to be getting some interference, tracks moving without touching the joystick or running in the wrong direction than it should be. Shutting things off then starting again seems to fix this for a while , but it comes back. Is there a break in procedure I should be doing and could it be static that is causing the interference? should I run a grounding cord from the tank to the ground? With the wires running right into the motor housing where would I solder any capacitors to eliminate electrical noise? Sorry if none of this makes sense my electrical knowledge is limited. Any advice would be appreciated. Thanks Greg --~--~---------~--~----~------------~-------~--~----~ You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [EMAIL PROTECTED] Visit the group at http://groups.google.com/group/rctankcombat -~----------~----~----~----~------~----~------~--~---
