I use similar boots, and design the penetration so the insulation and
wrap ( we use aluminum) nearly cover the whole boot by the time you're
all done. you're left with about 1/2" of boot showing all the way around.
where can I get the coolie cap style brazed copper flashings?
karl
Todd Cory wrote:
I use accordion style rubber boots. These are typically attached to
the roofing with a bead of silicone underneath and gasketed metal
roofing screws on top. These are made for all kinds of metal roof
penetrations and I have even seen them used for 6" metalbestos stove
flues. One note of caution, the orange "high temperature" ones are (I
think) rated only to 180 degrees F. so you want to make sure the SHW
fluid never exceeds this. Also in time, like any rubber flashing on a
roof the rubber will deteriorate from UV. I build a show shed over my
system's plumbing which shades it so hopefully this will not be in
issue in ~20 years.
Todd
troy Harvey wrote:
Any thoughts on how to flash a copper pipe roof penetration on a
metal roof. The brazed copper flashing we typically use would cause
corrosion with the steel roof I'm afraid. WHat have others used in
this situation?
Troy Harvey
---------------------
Heliocentric
801-453-9434
[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>
------------------------------------------------------------------------
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
--
Karl Schwingel
NABCEP Certified Solar Thermal Installer
NorthWind Renewable Energy LLC
PO Box 723 Stevens Point, WI 54481
[EMAIL PROTECTED]
Cell: 715 209 0446
Fax : 715 952 4501
This e-mail message is confidential, is intended only for the named
recipient(s) above, and may contain information that is privileged or
exempt from disclosure under applicable law. If you have received this
message in error, or are not a named recipient(s), you are hereby notified
that any dissemination, distribution or copying of this e-mail is strictly
prohibited. If you have received this message in error, please immediately
notify the sender by return e-mail and delete this e-mail message from
your computer. Thank you.
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org