Blue Sky has 15 and 30 amp, 12 and 24 volt charge controllers that are each independently MPPT that can be networked to their controller to communicate and charge a single large battery bank. Jeff Irish Hudson Solar
From: re-wrenches-boun...@lists.re-wrenches.org [mailto:re-wrenches-boun...@lists.re-wrenches.org] On Behalf Of Allan Sindelar Sent: Thursday, October 11, 2012 1:04 PM To: RE-wrenches Subject: [RE-wrenches] Fwd: Charge control question Wrenches, I'm posting this for Carl Bickford, prof emeritus of the renewable energy training program at San Juan College in Farmington, New Mexico. I'll forward your responses to him. I have a very interesting and talented friend who is rebuilding a blue-water sailboat for a round-the-world trip. He is well versed in solar and is trying to use a relatively large array to charge a big battery bank that will be used for propulsion as well as general electrical. The propulsion system will be backed up with a propane generator he is building himself out of a Toyota truck engine. As you can imagine, there is no place on a sailboat where shading isn't a problem. He and I were wondering if there were products out there that could MPPT either individual modules, or small groups of them for 12 V battery charging. I have seen such things for the inputs of grid-tied inverters, but nothing yet for off-grid. The other choice is to go with many small MPPT charge controllers like the ones from Solar Converters. Any advice you can offer? Take care, Carl Carl Bickford Professor of Engineering and Renewable Energy San Juan College 4601 College Blvd. Farmington, NM 87402 505-566-3503 bickfo...@sanjuancollege.edu<mailto:bickfo...@sanjuancollege.edu> I offered the suggestion below. Certainly open to other and better ideas. Allan I have not encountered this situation, so I have no advice from experience. At 12V, it's hardly an issue as it is with high voltage parallel strings, where a few shaded cells can cause a whole string to drop out of the inverter's MPPT. At most, a shaded cell weakens the output of that module. And since it's charging batteries, there's a greater amount of head room. I would suggest looking into Blue Sky Energy's "i" series - smaller MPPT controllers that can be networked. We seldom use them, as our residential applications are different. But you could put a controller on a group of modules and network several together. One advantage, I think (you'd want to check this) is that Blue Sky's MPPT algorithm is analog, unlike Outback and others: on the old Solar Boost series, the MPPT boost was set with a trim pot to a particular voltage above battery voltage; the target is to set it to where the boost was greatest. You could set this boost slightly lower than peak, and output just a little below MPP. That way the overall output would be minimally reduced, and a modest amount of shading would not cause the shaded module to drop below collective MPP as readily. Allan Sindelar al...@positiveenergysolar.com<mailto:al...@positiveenergysolar.com> NABCEP Certified Photovoltaic Installer NABCEP Certified Technical Sales Professional New Mexico EE98J Journeyman Electrician Founder and Chief Technology Officer Positive Energy, Inc. 3209 Richards Lane (note new address) Santa Fe, New Mexico 87507 505 424-1112 www.positiveenergysolar.com<http://www.positiveenergysolar.com/> -- This message has been scanned for viruses and dangerous content by Hudson Valley Computer Services<http://www.hvcomputerservices.com/>, and is believed to be clean.
_______________________________________________ List sponsored by Home Power magazine List Address: RE-wrenches@lists.re-wrenches.org Options & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org
