My understanding has been that the Soladeck has only been listed for DC
wiring. Perhaps they have a manufacturer rep on RE-wrenches that can
clarify.
Kent Osterberg
Blue Mountain Solar, Inc.
www.bluemountainsolar.com
On 11/25/2012 6:20 AM, Dave Palumbo wrote:
Rich,
We have been using SolaDeck PV roof mount enclosure. NEMA 3R with a flashed
penetration. Can use for combining, or simply as a pass through box.
Dave
David Palumbo
Independent Power LLC
462 Solar Way Drive
Hyde Park, VT 05655
www.independentpowerllc.com
NABCEP Certified PV Installer
Vermont Solar Partner
25 Years Experience, (802) 888-7194
-----Original Message-----
From: re-wrenches-boun...@lists.re-wrenches.org
[mailto:re-wrenches-boun...@lists.re-wrenches.org] On Behalf Of Rich Nicol
Sent: Sunday, November 25, 2012 8:11 AM
To: 'RE-wrenches'
Subject: [RE-wrenches] Best practices for conduit penetration on roof
Wrenches,
We typically run conduit for roof mounts over the edge of the roof to the
eaves, rather than penetrate the roof whenever possible. An upcoming
installation on an freshly asphalt shingled roof requires that we penetrate
the roof for the conduit run (Enphase). I'm wondering if there are any
suggestions for preferred flashing products and best known practices. It's
always seemed to me that the typical Oatey type flashing dries and cracks
eventually.
Thanks for your insights..
Rich
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org