Hi William Thanks
I've got the V set points done and it will manually turn on/off the genset via the SCP, so that works, but voltstime get below set points, or so it seems Of course it's 2 hrs each way with bad cell service. Just trying to get the most info before I go out there and do the sit there and see if it starts. Thanks. Jay Sent from my iPhone On Dec 26, 2012, at 8:26 PM, William Miller <will...@millersolar.com> wrote: > Jay: > > You may THINK you have all the settings right but the SCP is not intuitive. > I have a nagging feeling that I have gone through this and found some > disassociated menu with a setting that needed to be changed. I will peruse > the manual and see if I find anything. > > I use to think the output was open collector (wet) but I was told it was a > dry reed relay, so polarity should not be an issue. I would ohm the > disconnected leads to ground in the diode mode, using both lead polarities to > verify. Although if you have manual start you have already bypassed this > possibility. > > Can you try setting the start voltage a volt above whatever your battery > voltage is at the moment for testing. > > Setup if more trouble than it should be. I use Gen. Type 2 for two wire > starting. > > Good luck. > > William > > PS: Have you checked the menus: AGS/CFG Trigger/Start DCV 30 sec through DCV > 24 hour? They come disabled and the auto start will not work unless one or > more are enabled. This is unlike the SW which came with the triggers enabled > by default. This may be what I was thinking of. > > WM > > > At 05:52 PM 12/26/2012, you wrote: >> > Hi all >> >> I've got a client with a XW and AGS. >> >> >> When I go there, manual on/off works. >> >> He says however that it will not auto start, ie system shutdown due to low >> voltage >> >> I thought I've got all the settings right, but ?? >> >> Any ideas? >> >> Thanks >> >> Jay >> >> Peltz power >> _______________________________________________ >> List sponsored by Home Power magazine >> >> List Address: RE-wrenches@lists.re-wrenches.org >> >> Options & settings: >> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org >> >> List-Archive: >> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org >> >> List rules & etiquette: >> www.re-wrenches.org/etiquette.htm >> >> Check out participant bios: >> www.members.re-wrenches.org >> >> No virus found in this incoming message. >> Checked by AVG - www.avg.com >> Version: 8.5.455 / Virus Database: 271.1.1/5487 - Release Date: 12/25/12 >> 19:34:00 > > Miller Solar > Voice :805-438-5600 > email: will...@millersolar.com > http://millersolar.com > License No. C-10-773985 > > _______________________________________________ > List sponsored by Home Power magazine > > List Address: RE-wrenches@lists.re-wrenches.org > > Options & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out participant bios: > www.members.re-wrenches.org > _______________________________________________ List sponsored by Home Power magazine List Address: RE-wrenches@lists.re-wrenches.org Options & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org
