Friends:
I installed a Flexmax 100 today in a dual FX system circa 2003. The system has an oval Mate and it is no surprise the old Mate does not communicate with the FM100 as this was made clear from the literature. I plugged in a new Mate3S directly into the FM100 hoping to connect and see data, but alas, the display was almost entirely blank. It only showed the battery voltage which was 500 volts, which I guess is a promotion. I then tried plugging the FM100 into a Hub 10.3 and then into the Mate3S. Still no display. I’d like to field-check the FM100 with a Mate3 or 3S but don’t know how. It used to be you could plug an MX60 into a Mate and get some semblance of normality displayed. Can I swap out the old hub with a 10.3 with the inverters connected and get FM100 data? Any ideas out there? Thanks in advanced. William PS: The FM100 is charging so that is not an issue. Wm Miller Solar 17395 Oak Road, Atascadero, CA 93422 805-438-5600 www.millersolar.com CA Lic. 773985
_______________________________________________ List sponsored by Redwood Alliance List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org There are two list archives for searching. When one doesn't work, try the other: https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/ http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: http://www.re-wrenches.org/etiquette.htm Check out or update participant bios: http://www.members.re-wrenches.org