I am am receiving an error return value from a module that I have written however the return code is not one I have define, nor is it none from errno.h (numbers 0 to 124) nor 126 or 127. Signals.h does not also have values that high (0 to 31) when added to128 as reported by bash. The return value is 198. I have gone through various modules thier code and tried to find what this means to no avail. The error does not occurr at any particular time or during the same operation. This module has been operating over more than 2 years with no problem, does it indicate a hardware fault ?
Any Ideas Thanking You John John Whitton Equipment Software Engineer - Corporate Mitek Australia Ltd 46 Monash Drive Lyndhurst VIC 3975 Ph: 61-3-8795 8888 Fx: 61-3-8795 8800 Mob Int: 61-4-02296139 Mob Local: 0 402 296139 ------------------------------------------------------------------ This communication (including any attachments) contains information which is confidential and may also be privileged. It is for the exclusive use of the intended recipient(s). If you are not the intended recipient(s), please note that any distribution, copying or use of this communication or the information in it is strictly prohibited. If you have received this communication in error, please notify the sender immediately and then destroy any copies of it. -------------------------------------------------------------- _______________________________________________ Redhat-devel-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/redhat-devel-list
