I'm having issues with one last remaining issue with my 100mW NL2011CD PLUS
EXT2 card (basically the EnGenius/Senao/Intersil one). I can't get it to
"work" for getting online, however it does work fine with "kismet" and also
"wavemon". I've searched google and found a few other references to this,
but no solution was posted. Anyone have ideas? This is with RedHat 9
(shrike) from fresh install.
[EMAIL PROTECTED] X11]# ifup wlan0
Error for wireless request "Set ESSID" (8B1A) :
SET failed on device wlan0 ; Invalid argument.
[EMAIL PROTECTED] X11]# ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 00:02:6F:01:B9:AF
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:10 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:3720 (3.6 Kb)
Interrupt:3 Base address:0x100
[EMAIL PROTECTED] X11]# iwconfig
wlan0 IEEE 802.11b ESSID:"test"
Mode:Master Frequency:2.422GHz Access Point: 00:02:6F:01:B9:AF
Bit Rate:11Mb/s Tx-Power:3 dBm Sensitivity=1/3
Retry min limit:8 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
dmesg outputs:
hostap_crypt: registered algorithm 'NULL'
hostap_cs: 0.0.3 - 2003-05-18 (Jouni Malinen <[EMAIL PROTECTED]>)
hostap_cs: setting Vcc=33 (constant)
hostap_cs: CS_EVENT_CARD_INSERTION
prism2_config()
hostap_cs: setting Vcc=33 (from config)
Checking CFTABLE_ENTRY 0x01 (default 0x01)
IO window settings: cfg->io.nwin=1 dflt.io.nwin=1
io->flags = 0x0046, io.base=0x0000, len=64
hostap_cs: index 0x01: Vcc 3.3, irq 3, io 0x0100-0x013f
divert: allocating divert_blk for wlan0
hostap_cs: Registered netdevice wlan0
prism2_hw_init()
prism2_hw_init: initialized in 9194 iterations
wlan0: NIC: id=0x8003 v1.0.0
wlan0: PRI: id=0x15 v0.3.0
wlan0: STA: id=0x1f v1.3.4
wlan0: defaulting to host-based encryption as a workaround for firmware bug
in Host AP mode WEP
wlan0: defaulting to bogus WDS frame as a workaround for firmware bug in
Host AP mode WDS
wlan0: Host AP mode does not support 'Any' essid
wlan0: prism2_open
wlan0 unsupported ioctl(0x8947)
--
redhat-list mailing list
unsubscribe mailto:[EMAIL PROTECTED]
https://www.redhat.com/mailman/listinfo/redhat-list
